EckTec

Replacing conventional braces is an absolute breeze with the EckTec connector. Using the EckTec connector creates an attractive appearance without any bothersome braces. This is particularly beneficial for low installation heights.

Material

• EN-AW 6063-T66 (AlMgSi0,5)

Adavantages

• Supports load absorption with horizontal forces
• Pre-assembly at the factory optional
• For versatile use

Instructions for use
The EckTec connector is fixed with two 3,5 x 40 Paneltwistecs. The fi rst KonstruX ST 8 x 155 fully-threaded screws are then set at 25° in the posts. After mounting the cross beam, the other 8 x 95 KonstruX ST fully-threaded screws can be set at 90°.
Further information on static pre-dimensioning can be found in our separate pre-dimensioning sheet.
* Width x height x depth